Raptor Scanner Calibration

Calibrate Scanner

You should always calibrate your scanner and perform a test scan after the software is installed. Use the Utilities tab in the Raptor Hardware Service Manager to calibrate and perform a test scan.

Note:

Calibration only applies to the ScanShell 800DX scanner. Calibration is not required for the 3M CR5400 scanner.

Perform the following steps to calibrate the scanner:

  1. Open the Raptor Hardware Service Manager and select Utilities in the navigation menu.
  2. On the Scanner tab, insert the calibration paper into the scanner and click Calibrate.

Test Scanner

You can also test the scanner from this workspace.

Insert an ID card into the scanner and click Test Scan. The results of the last scan display in the lower pane.

LastScanResults_675x486

Title

Calibrate Scanner

URL Name

Calibrate-Scanner-7bd91088

Created by Robert Ocampo, on 11/3/2022