Raptor Technology
Raptor Technology
How to Set Up and Use the Raptor CR5400 Duplex Scanner
How to Set Up and Use the Raptor CR5400 Duplex Scanner This article describes how to set up and use the CR5400 Duplex scanner. Install 3M Drivers _**Before connecting the scanner**_ to your computer, you must install the 3M drivers for the CR5400 scanner. Perform the following steps to install th...
Install Dymo Print Driver
Install DYMO Printer Drivers Perform the following steps to install the DYMO printer drivers: Log in to Raptor and select Support in the left navigation pane. Click Go To Downloads. If your district has the Client Portal page enabled, click More Support Resources > Go to Downloads. Click the ...
Install Individual Raptor Components
Install Individual Raptor Components You can install all the components individually instead of running the all-in-one installer.Perform the following procedure to install Raptor individual components: Log in to Raptor and select Support in the left navigation pane. Click Go To Downloads. If y...
Install Raptor Hardware Service
Install Raptor Hardware Service Perform the following procedure to install the Raptor Hardware Service:1. Log in to Raptor and select Support in the left navigation pane.2. Click Go To Downloads. If your district has the District Portal page enabled, click More Support Resources > Go to Downloads...
Raptor Hardware Service Manager
Raptor Hardware Service Manager The Raptor Hardware Service Manager is used to view the status of the system, specify printer settings, calibrate and test your scanner, register the SSL certificate and view the printer and scanner logs.You launch it from the Installation Complete panel of the Rap...
Installing Raptor
Installing Raptor IMPORTANT!If you are using a version of Raptor vSoft that was installed prior to May 2017 (version 10.12.03.13 or earlier), you must manually uninstall all vSoft components before proceeding. Refer to Uninstall Raptor vSoft.You install Raptor from the Raptor Support Center. Perf...
Raptor Scanner Calibration
Calibrate Scanner You should always calibrate your scanner and perform a test scan after the software is installed. Use the Utilities tab in the Raptor Hardware Service Manager to calibrate and perform a test scan.Note:Calibration only applies to the ScanShell 800DX scanner. Calibration is not re...
Raptor Hardware System Status
Status Overview Shows Devices Disconnected When viewing the Status Overview workspace in the Raptor Hardware Service Manager, the devices (printer, scanner or both) show as not connected.Restart the Raptor Hardware Service to resolve the issue: In the lower right corner of your screen, click th...
Scanner Calibration
How to calibrate the scanner